If I try to burn bootloader, it says "error while trying to burn bootloader" - "avrdude: usbdev_open(): did not find any USB device "usb" Error while burning bootloader." "avrdude: stk500v2_getsync(): timeout communicating with programmer" If after this I connect the arduino again via usb and try again to upload "blink" via AVRISP mkII, it gets stuck in the uploading. please check for usbasp firmware update." There is no blinking in the led, so the sketch is not working. It says "done uploading", and again also says "avrdude: warning: cannot set sck period. please check for usbasp firmware update." Arduino´s led start to blink It says "done burning bootloader", but also says "avrdude: warning: cannot set sck period. I am trying a USBasp that I got following the information on this post.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |